The Company of Choice in Kasson for Basement Waterproofing, Radon Mitigation, & Foundation Repairs

A homeowner in Kasson, MN was tired of dealing with the issues in his front driveway. There were multiple sunken slabs that created small bumps that were very noticeable every time his car had to drive over it. He also wanted to get rid of the weeds and grass that was growing in the joints in between the slabs because of how much they separated. He decided to go online and looked up "how to fix sinking driveway" in hopes of finding a solution sooner than later. He found the American Waterworks company website through the searching and decided to go with us and sign up for a FREE estimate after reading so many positive customer reviews. We received his request and sent over one of our Design Specialists, Romeo Vilai, to the home to inspect the concrete. From his experience, Romeo knew that the driveway was in need of lifting and leveling from our PolyLevel foam. The homeowner trusted his judgement and agreed to the installations. Later, one of our Foreman, Dylon VanCanneyt, and his crew went to the site to begin the project. They drilled small holes around the driveway and inserted ports through them to connect to the empty space below the concrete. Then they injected the PolyLevel through the ports until lifted to the original height. Once everything was lifted, the crew filled in the holes and remaining joints with NexusPro, a flexible sealant that provides long-lasting results and durability. To finish the project, a layer of native sand was placed on top of the sealant for a smooth and pleasant look to the driveway. Our crew made sure the homeowner was happy with the results before packing up their materials and leaving the site. 

If you're unhappy with your driveway, give us a call to get your FREE estimate set up!

A homeowner in Kasson, MN, was worried about the status of their basement after discovering a musty smell. Unsure of what was causing the smell, the homeowner knew they needed an expert's advice. The homeowner asked their friend who had a similar issue and they recommended American Waterworks. Trusting their friend's advice, the homeowner decided to sign up for their FREE estimate. Once the estimate was set, we sent Nick, one of our Design Specialists, to complete the investigation. Nick arrived at the home and began his detailed investigation. Nick discovered wet spots in the carpet and knew the basement needed additional waterproofing. Nick alerted the homeowner of his findings and suggested a solution that would solve all of the issues. Knowing this was their best option, the homeowner agreed with Nick's suggestions. After getting the stamp of approval, our Foreman, Gabriel, and his crew were assigned to complete the project. When they arrived at the home, Gabriel and his crew began by installing the WaterGuard around the entire basement. The WaterGuard is a below-floor drain that rests in a bed of drainage stone on top of the foundation footing. The crew installs the WaterGuard by digging channels around the perimeter of the basement floor. Once the channels are dug, the crew can go ahead and place the drainage stone in the channels. The WaterGuard is then placed on top of the stone and covered with cement. After the WaterGuard was installed, the crew took out the old sump pump and replaced it with the TripleSafe sump pump. To connect the TripleSafe to the WaterGuard, the crew installed a feedline across the foundation floor. Next, the crew mechanically attached CleanSpace to the basement walls. CleanSpace is a 100% waterproof plastic vapor barrier that is ideal for foundation walls. The crew installed the IceGuard, an anti-freeze fitting, on the outside discharge line. Once the project was complete, the crew took down the protective plastic and cleaned up their materials. The homeowner was relieved to know their basement no longer smelled musty. If you are experiencing a similar issue, sign up for your FREE estimate today!

Wilma J. in Kasson, MN contacted us with concerns about her sinking front stoop. She saw one of our advertisements in the newspaper and was interested to learn more about the PolyLevel solution that we provide. She spoke to one our Design Specialists and was happy to learn that our PolyLevel injection is a faster, more affordable and durable solution for concrete repair. 

Within a few hours of the injection, Wilma could see the drastic difference the PolyLevel injection had made. American Waterworks was able to successfully raise and level her concrete slabs and she was pleased with how quick and non-invasive the process was.